#Eaa witness upgrade#

That said, if the Witness is a small-frame TZ-75 quite a few of the parts will inter-change (think most of them really), if it's a large-frame Witness then that's a different story entirely, but you'll still be able to get quite a few upgrade parts from Henning W.

I suggest you check out the 'Clone Club' over at, they'll have all the info you'll need. PS for pars dont worry abut CZ comparability just go to Hennings site and get everything you need there. this helps lessen the 2 stage feel the trigger has in stock form.Д¤ the last bit of grit you will feel in the DA trigger pull is the bottom of the sear rubbing on the hammer I don't find this to annoying and it only takes about 1K rounds for it to go away on its own.ДҐ If the SA pull has lots of creep you may need to shorten you hammer hooks to lessen the engagement I have only had to do that on one hammer so far so that is probably ok. Hammer spring strut, this is more of a sand off the rough spots than a polish.ДЈ put a little polishing compound mixed with oil on the engagement surfaces on the DA interrupter and the trigger bow assemble and dry fire DA about 20 times, disassemble and clean, oil and reassemble and test trigger repeat till the trigger feels the way you want. Sear housing, bottom where trigger bow rubs, groove in bottom where interrupter rides. Trigger bow, sides where it rubs on frame, groove on bottom where plunger rides, top of back where it rubs on the sear housing.ДЇrame, groove in front of hammer where DA interrupter rides

Here is what I do to get a good DA trigger on a Witness/TanfoglioДЎ change main(hammer)spring to a lighter one I have had good luck with the wollf 14 lb still setting off CCI primersДў polish polish polish.

Eaa witness